400
6.
Tighten the nut (8) on the tip side of the head pin (13).
7.
Remove the nut (8), the plate (7) and the collar (6) on the tip side
of the point pin (5) and pull out the point pin (5) to remove the
searcher hook bracket (4).
The searcher hook bracket (4) will fall when the point pin (5)
is pulled out; be sure to support the bracket and pull the pin
out slowly.
NOTES
The searcher hook bracket (4) should be hung from the head pin
(13) by its design; remove by pulling it out toward you.
8. Tighten the nut (8) you loosened in step 6.
9. Secure the searcher hook bracket (4) you have removed with
the eye bolt (15) and the washer (16) to the stowage bracket
(14) on the front of vehicle and stow it.
To Next Page
Loading...
