Maeda MC815C - Page 8

vi
Item
Page
INSPECTION AND MAINTENANCE
245
1. PRECAUTIONS FOR MAINTENANCE 246
2. BASIC MAINTENANCE 248
3. LEGAL INSPECTION 251
4. PERIODIC REPLACEMENT OF IMPORTANT COMPONENTS 252
5. CONSUMABLES 253
6. LUBRICATING OIL 254
6.1 USE OF LUBRICATING OIL ACCORDING TO TEMPERATURES 254
7. ACCESSORY TOOLS AND STANDARD TIGHTENING TORQUE 255
7.1 LIST OF STANDARD TIGHTENING TORQUE 255
7.2 LIST OF HOSE TIGHTENING TORQUE 256
8. INSPECTION AND MAINTENANCE LIST 257
9. MAINTENANCE PROCEDURES 260
9.1 PRE-OPERATION INSPECTION 260
9.1.1 INSPECTION BEFORE STARTING ENGINE (PATROL) 260
9.1.2 INSPECTION BEFORE STARTING ENGINE 263
9.1.3 INSPECTION BEFORE STARTING ENGINE (RADIO CONTROL) 275
9.1.4 INSPECTION AFTER STARTING ENGINE 278
9.1.5 INSPECTION OF ENGINE START AND STOP OPERATION (RADIO CONTROL) 285
9.2 IRREGULAR MAINTENANCE 289
9.3 INITIAL 10 HOUR MAINTENANCE 300
9.4 INITIAL 50 HOUR MAINTENANCE 300
9.5 INITIAL 250 HOURS MAINTENANCE 300
9.6 EVERY 50 HOURS MAINTENANCE 301
9.7 EVERY 100 HOURS MAINTENANCE 305
9.8 EVERY 250 HOURS MAINTENANCE 306
9.9 EVERY 500 HOURS MAINTENANCE 310
9.10 EVERY 1000 HOURS MAINTENANCE 318
9.11 EVERY 1500 HOURS MAINTENANCE 326
9.12 EVERY 2000 HOURS MAINTENANCE 326
9.13 EVERY 3000 HOURS MAINTENANCE 327
SPECIFICATIONS
329
1. PRINCIPAL SPECIFICATIONS LIST 330
2. SPECIFICATION DIMENSIONAL DRAWING 333
3. DIMENSIONAL DRAWING OF OUTRIGGER WIDTH 334
4. RATED TOTAL LOAD CHART 335
4.1 6 FALL HOOK 335
4.2 4 FALL HOOK 338
4.3 2 FALL HOOK 341
4.4 SINGLE FALL HOOK 344
5. WORKING RADIUS/LIFTING HEIGHT 347
6. WORKING RADIUS AND LIFTING HEIGHT (DURING PICK & CARRY) 348