PROBLEM 3
Engine runs, but no hydraulic operation.
POSSIBLE CAUSES
Clutch not engaged; No hydraulic fluid in tank; Blocked charge inlet to pumps; Clogged tank vent;
Drive train damaged from flywheel to pump mount.
CHECKS
Check hydraulic filter service shut-off valve.
Ok Not Ok
Check clutch engagement.
Open filter service shut-off valve or
replace filters if necessary.
Clutch Engaged Clutch not Engaged
Engage clutch.
Remove tank cap and check vent, fluid level, and viscosity. In extreme cold
conditions, oil may not flow freely to pump inlets causing pump cavitation.
Tank Vent, Oil Level, Viscosity Ok Not Ok
Service hydraulic system.
Check manual override on two or more pumps. Does engine load when
manual override is applied? Make sure all brakes are applied and swing
lock is in place. (See Te st
11.)
Pump Loads
Pump does not Load
Check electrical input from controller
to pump. (See Te st
5.)
Consult
dealer/factory.
To Next Page
Loading...
Need help?
General
