Starting the engine for driving / switching it off
4.1 Starting the engine from the driver's cab
Operating manual 3 302 690 en 4 - 15
GMK4100L-1
23.11.2017
4.1.9 Checks after starting the engine
Start menu and
on-board
computer
• Check if the display area of the main menu
(1) or the on-board computer display (2)
shows any red symbols
– Display area (1) – when a symbol is red;
à Malfunctions on the engine, p. 8 - 19.
– On-board computer display (2) – when a
warning message or symbol is shown;
à Warning and malfunction messages on the
on-board computer display
, p. 8 - 9.
• If a red symbol lights up, or if a message
demands it, switch the engine off
immediately.
• Also check the following displays
The colour of the bar under the value indicates
the range within which the value lies.
s
S
Risk of damage to the engine
Observe the symbols and messages in the display area of the main menu
and in the on-board computer. By this means you avoid low oil pressure
leading to engine damage.
1 Voltage in volts
2 The hydraulic oil temperature in °C (°F)
3
AdBlue supply in percentage
Green: Value OK
Yellow: Limit value almost reached
Red: Limit value exceeded (or not
reached) – warning message;
à p. 8 - 13.
To Next Page
Loading...
