Driving modes
6.4 Rigging the auxiliary hoist
Operating manual 3 302 690 en 6 - 17
GMK4100L-1
23.11.2017
6.4 Rigging the auxiliary hoist
You will require the following equipment with a sufficient load bearing
capacity:
– An auxiliary crane
– Suitable lifting gear and guide ropes,
– A separate vehicle.
Transport dimensions and weight;
à p. 1 - 14.
6.4.1 Slinging the auxiliary hoist
•
Sling the auxiliary hoist at the slinging
points (1).
Use suitable lifting gear with the same length,
so that the auxiliary hoist hangs at the centre
of gravity.
• Remove the bolts from the connecting
points (2).
S
Risk of damage to the auxiliary hoist and truck crane
Only sling the auxiliary hoist onto the slinging points provided. Always use
suitable lifting gear with sufficient lifting capacity.
To Next Page
Loading...
