Driving with a rigged truck crane
13.5 Driving from the crane cab
13 - 18 3 302 690 en Operating manual
GMK4100L-1
23.11.2017
13.5.1 Preparing to drive
•
Make sure that the rigging mode for driving with a load or without a load
is set correctly;
à p. 13 - 2.
In the driver's cab
– The ignition key must be in position 1 so that the steering cannot block.
– The driver's cab must be locked with the second ignition key in order to
secure it against unauthorised use – e.g. braking.
– The parking brake is engaged.
In the crane cab
– The ignition must be switched on.
– The hand-held control must be disconnected and bridging plugs plugged
into all the sockets.
– The superstructure must be locked.
– The parking brake is engaged.
13.5.2 Opening/closing the Driving menu
Opening
The brake pedal (1) must be depressed.
Manual
• Select and confirm the symbol (1).
or
Automatic
• Push the button to the top – release the parking brake.
The
Driving menu opens.
To Next Page
Loading...
