Driving modes
6.5 Installing/removing the outrigger beams
6 - 30 3 302 690 en Operating manual
GMK4100L-1
23.11.2017
6.5.1 CHECKLIST: Removing the outrigger beams
H
This checklist is not a complete operating manual. There are accompanying
operating instructions which are indicated by cross-references.
Observe the warnings and safety instructions specified here!
1. Preparing the truck crane;
à p. 6 - 35.
2. Label the outrigger beams, retract, release and bolt them to each other;
à p. 6 - 34.
3. If necessary, remove the outrigger pads;
à p. 6 - 36.
4. Unscrew the spacer;
à p. 6 - 40.
5. – Disconnecting hydraulic connections;
à p. 6 - 38.
– Disconnect the electrical connection if necessary;
à p. 6 - 39.
To Next Page
Loading...
