Rigging work
12.5 Starting the engine for rigging
Operating manual 3 302 690 en 12 - 27
GMK4100L-1
23.11.2017
12.5 Starting the engine for rigging
For rigging work, you can also start the engine from the outrigger control
units.
H
You can generally start the engine only if a bridging plug is inserted in all
sockets not required.
Prerequisites The following requirements must be met before you can start the engine for
driving from the outrigger control units:
– The ignition in the driver's cab must be switched on.
– The ignition in the crane cab must be switched off.
Starting the
engine
All activities and inspections required to start the engine must be carried out
before starting the engine;
à p. 4 - 1.
The lamp in the button (1) lights up.
• Press the (1) button once – the engine starts.
Turning off
the engine
• Press the button (1) once – the engine will switch off.
G
Risk of crushing due to turning wheels
When you start the engine, no persons may be within the steering range of
the 3rd and 4th axle lines. These axle lines can be briefly steered during the
start of the engine; sometimes with five seconds delay.
To Next Page
Loading...
Need help?
General
