Driving modes
6.5 Installing/removing the outrigger beams
Operating manual 3 302 690 en 6 - 35
GMK4100L-1
23.11.2017
6.5.5 Preparations – on the truck crane
Prerequisites The following requirements must be met before mounting/removing the
outrigger beams:
– All rigging work which involves slewing the superstructure has been
completed.
– The parking brake is engaged.
– The truck crane has been levelled with the level adjustment system;
à p. 5 - 53.
– The suspension is switched off (blocked), and the symbol (1) is red;
à p. 5 - 16.
– The corresponding covers have been removed (1).
– If necessary, the driver's cab may need to be tilted forward in order to
reach the separator points for the front right outrigger beam.
To Next Page
Loading...
