Crane operation
11.2 Standard slewing range type
Operating manual 3 302 690 en 11 - 21
GMK4100L-1
23.11.2017
11.2 Standard slewing range type
The MAXbase slewing range type is available in the case of additional equip-
ment;
à MAXbase slewing range type, p. 11 - 23.
The
Standard slewing range type is always available. The supplied lifting
capacity tables with symmetrical outrigger spans apply. These lifting capac-
ity tables are also supplied in printed form with the truck crane.
11.2.1 Permissible slewing ranges and working positions
360° slewing
range
• Support the truck crane with the outrigger span required according to the
Lifting capacity table.
• Enter an RCL code for the 360° slewing range according to the Lifting
capacity table
; à Enter rigging mode, p. 11 - 32.
• Rig a counterweight combination that is no larger than that permitted for
the rigged outrigger span. Slewing with a rigged counterweight is not per-
mitted with all outrigger spans;
à Slewing with rigged counterweight,
p. 12 - 97.
Working position
0° to the rear
• Support the truck crane with the outrigger span required according to the
Lifting capacity table.
• Slew the superstructure to the rear into the 0° position.
• Lock the turntable; à p. 11 - 15.
• Enter an RCL code for the 0° to the rear working position according to
Lifting capacity table; à Enter rigging mode, p. 11 - 32.
The RCL will accept this code only if the turntable is locked and the
superstructure is in the 0° position.
H
All slewing operations are disabled if an RCL code is entered for the 0° to the
rear
working position. An RCL shutdown is triggered by unlocking the turn-
table. To acknowledge this shutdown, if slewing is permissible with the
rigged counterweight (
à p. 12 - 97), set down the load and enter a rigging
mode for the 360° slewing range.
180° to the front
rigging position
The same lifting capacity tables apply to this position as to the 360° slewing
range.
To Next Page
Loading...
