Megger Baker DX - Page 153

Index
megger.com 143
overview of leads, fixtures, and accessories
used in testing 51
P
partial discharge testing
setting parameters 45
partial discharge testing overview and
preparation 81
partial discharge testing–single-coil mode 104
partial discharge testing–three-phase coil
mode 85
partial discharge testing–three-phase mode 81
PD data reporting—single-coil mode 108
PD data reporting–three-phase coil mode 91
PD event threshold 85
PD events detected / PD number of events 85
PD settings 45
PD signal samples per display pixel field 85
PD testing setup
checking and recording system noise level
83
PDEV 46
PDIV 46
performing PD tests–single-coil mode 104
performing PD tests–three-phase coil mode 85
phase angle 65
polarization index test 70
popup menus 23
positioning the Baker DX 47
power packs 12
power requirements 6
preparing for tests
PD testing–three-phase coil mode 81
printing reports 35, 39
Procedures for testing with the Baker ZTX 123
procedures for testing with the DX host 61
pulse counter 27
R
rear panel connections 10
recall reference feature 95
recommended test voltages 137
recommended testing sequence 61
reference waveform 93
remote E-stop and lights accessory 14
resistance test procedures 63
resistance test using DX host 61
restting test reference 94
RIC steps
setting 43
RIC test setup 60
RIC testing 118
RLC test procedure overview 62
RLC type
setting 43
rotor influence check test procedures 119
rotor influence check testing using DX
host 118
RPDEV 46
RPDIV 46
S
safety 2, 47
safety information 1
safety precautions 2, 47
Selecting insulation type 73
selecting test voltage for span test 111
self-help and diagnostics 127
setting EAR fail stop 43
setting HGG or HGO 43
setting parameters for partial discharge
testing 45
setting RIC steps 43
setting RLC type 43
setting temperature scale 43