Index
144 Baker DX 71-030 User Guide EN V10 www.megger.com
setting up fixtures, test accessories, and lead
connnections 51
setting up the AT101-ZTX 49
setup requirements 47
single-coil mode
PD testing 104
single-coil test 98
span armature test fixture 52
span test procedures 112
span tests using DX host 111
standards 135
status bar 19
step voltage test 70
Surge test 137
surge test procedure overview for three-phase
coil mode 77
surge test procedures 77
surge testing procedure for single-coil mode
98
surge testing procedure for three-phase coil
mode 78
surge tests using the DX host 77
Surveyor DX 17
SurveyorDX reports 17
switching active leads 101
symbols on equipment 1
system settings 41, 70, 78, 102
T
technical specifications, calibration, and
applicable standards 133
temperature and humidity
PD testing–three-phase mode 82
temperature scale
setting 43
test accessories 16
test and function modes
mode menu icon descriptions 20
test clips and probes 55, 56
test leads 9
test procedures 61
test selection controls 25
tester setup 47
touch screen 8
troubleshooting 127
U
user interface
main display area 19
mode menu 19
mode submenu 19
status bar 19
user interface overview 19
user settings 43
using non-test functions 29
using system settings 41, 70, 78, 102
using the recall reference feature 95
V
viewing coil test results 101
viewing existing data 32
voltage output control knob 9
voltage ramp rate
setting 43
W
warranty return 131
warranty return form 132
waveform selection 102
waveforms locked 88
waveforms unlocked 88
Z
ZTX armature testing 123
ZTX emergency stop 5
To Next Page
Loading...
