MG MGB - Front Anti-Roll Bar Locator Dimension

THE
FRONT
SUSPENSION
\\
A
IIHIIIIIIHHHHHII
.,
3))
Fig.
K7
’1'. ‘3.
‘9”
Q
g.
Front anti-roll
bar locator
dimension
(GHNS
and
GHDS
cars
from
Car
No.
410002)
A
=
9
1%
in (237
mm)
from
locator
inner
face
to
centre
line
of
car
Section
K.9
ANTI-ROLL
BAR
(GHNS
and
GHDS
cars
from
Car No. 410002)
Removing
l.
Raise
the
vehicle
and
support
the
chassis
member.
2.
Disconnect
the
anti-roll bar
from
the
support
link
on
each
side.
3. Swing
the
anti-roll bar
down.
4.
Remove
the
bearing
straps,
bearing
rubbers
and
anti-roll
bar.
5.
Remove
the locators
if
■tting
a new
anti-roll bar.
K.10
6. Check
the bushes
and
anti-roll
bar bearing
rubbers;
renew
if
worn.
Refitting
7.
8.
ll.
Fit
the bushes
and bearing
rubbers
to
the
anti-roll
bar.
Fit the
locators,
ensuring their
inner
faces
are
approximately
9
“1%-
in
(237
mm) (A)
from
the
centre
of
the roll
bar.
Fit
the
anti-roll
bar
to
the
longitudinal
members.
WARNING:
The
anti-roll
bar
must
be ■tted
with
the
crank
(bolt
eye
for
support
link)
facing
downwards.
Connect
the
anti-roll bar
to
the
support
link
on
each
side.
Lower the
vehicle.
MGB.
lssuel.
91427