MG MGB User Manual

Ba
THE
BODY
Section
Ra.8
THE
REAR
BUMPER
AND
OVER-RIDERS
(GI-INS
and GHDS
cars
from
Car
No.
339095)
Removing
1.
2.
Ra.8
Remove
the
two
nuts to
release
the bumper
assembly
from the mounting
brackets.
Unscrew
the
nuts
and
remove
the
three dome
headed
bolts,
noting
the distance pieces
■tted between
the
bumper
spring
and the bumper
bar.
Remove
each
over-rider
assembly
retaining
bolt
to
separate
the
over-rider
assembly
and
its
support
casting
from
the bumper
bar
and bumper spring,
noting
the large
distance piece
■tted between
the
bumper
bar
and
bumper
spring.
If
it is
necessary
to
dismantle
the
over-rider
assembly
proceed
as
follows:
a.
Mark
the
over-rider
clamping
bracket
and the
mounting
bracket
at
the
top
to
assist‘
reassembling.
“
b. Remove
the clamping bracket
securing
screws
and
remove
the clamping bracket.
0.
Slide
the
mounting
bracket
from the over-rider.
Refitting
5.
Reverse
the procedure
in 1
to
4,
referring
to
Fig. Ra.7
and
noting
the
following:
a.
Ensure that the
over-rider
is
correctly
■tted
to
the over-rider.
b.
Ensure that each over-rider
assembly
and
support
casting is
■tted
to
its
correct
side
of
the bumper
as
over-rider assemblies
are
handed left and right.
c.
The
■tted
position
of the over-rider
assembly
retaining
bolt
is
at
an
angle;
ensure
when ■tting
not to
damage the thread.
MGB.
Issue 1.
86842

MG MGB Specifications

General

Brand	MG
Model	MGB
Category	Automobile
Language	English