MIMAKI JV330 Series User Manual

Chapter 5 Using the XY Slitter
153
8
Align the groove in the X cutter with the printed guide line, embed the blade in the media, then
raise the lever to secure.
Set X cutter
[ENT]
Left guide line
Lever
Right guide line
• Avoid touching the cutter blade. Failure to do so may result in injury.
• Slide out the unused X cutter, or move it away from the media and secure it by raising the
lever. If you start printing with the lever being lowered (unsecured), the X cutter may hit
the XY carriage and result in damage.
9
Raise the XY clamp lever.
• Hold the media.
Up the clamp lever of XY Slitter
• Note that the carriage moves when the clamp lever is raised.
10
Unlock the tension bar of the XY slitter.
• Tension is applied to the media.
5

MIMAKI JV330 Series Specifications

General

Brand	MIMAKI
Model	JV330 Series
Category	Printer
Language	English