Minebea Intec PR 5230 - Page 181

1. Select [Printer] and conrm.
A selection window opens.
2. Select the desired interface and conrm.
The selected interface is displayed.
3. Press the [Param] softkey to set the parameters.
The following window opens:
4. Select parameters and conrm.
5. Select and conrm the desired printer settings in the respective selection window.
6. Press to return to the previous window.
7. Press the [Cong] softkey to dene the print settings.
Transmitter in eld housing PR 5230 7 Commissioning
Minebea Intec EN-178