Minebea Intec PR 5230 - Page 246

Example:
Type Date Time Code Cond
Indicator 2013-06-24 11:01:18 AM 265 on
fatal error 2013-06-23 4:52:29 PM 2050 on
Powerfail 2013-06-24 10:15:57 AM 0 on
Setup 2013-06-24 10:59:57 AM 1025 on
fatal error
Code Event
2049 Watchdog
2050 Fatal Error
2051 Reset completed.
2052 Assert error
2053 Exception error
2054 Hardware error
Setup
Code Event
512 New Calibration was started.
513 Dead load was reset with mV/V.
514 Span was reset with mV/V.
515 New dead load was reset with weight.
516 New span was reset with weight.
517 New scale end value was reset.
518 New verication interval was set.
519 Calibration was saved.
520 Changes were undone.
768 Wrong PIN was entered.
769 EAROM was cleared.
771 Device was turned on.
1024 Serial parameters were saved.
1025 Assignment of serial interfaces was changed.
1027 Network parameter were changed.
1028 Printer parameter were changed.
1029 Software parameters were changed.
1030 Fieldbus parameters were changed.
9 Extended functions Transmitter in eld housing PR 5230
EN-243 Minebea Intec