Minebea Intec PR 5230 - 4.4.8.2 Opto-decoupled outputs; 4.5 Connecting analog load cells and platforms; 4.5.1 General information; 4.5.2 Connecting a load cell with a 4-wire cable

Input eld
In principle
If alphanumeric characters are already present in the input eld of
the selected line, they will be completely overwritten after imme-
diate entry.
If alphanumeric characters are already present in the input eld of
the selected line, you can press the cursor key to select the
characters to be overwritten and overwrite them.
3.4.4.3 Operation using softkeys
The functions of the ve softkeys below the graphic display are indicated in the
bottommost text line of the display. Softkey functions shown in gray cannot be selected
at the active menu level or with the current access privileges.
In the descriptions of operating sequences which entail the use of softkeys, the softkey
function to be selected is shown in square brackets; the softkey symbol is not displayed;
example: [Calib].
3.4.4.4 Navigation key operation
Menu
The cursor keys, the and keys are used to navigate through the menus.
Parameters
Use the cursor keys to select the individual parameters.
Use the key to conrm the selection.
The required values | texts are entered via the alphanumeric keys.
The key is used to check the ☑ box.
If the list of parameters is long, a vertical bar graph on the left (black and gray) shows
which part of the list is displayed.
3 Device description Transmitter in eld housing PR 5230
EN-25 Minebea Intec