Function keys/softkeys
Access the Setup menu.
Depending on the settings under
-[Weighingpoint]- [Calib]- [Param]- [Test
mode] the following is displayed by calling
the test with the key later on:
- with "Absolute" the maximum load
- with "Relative" the deviation from test
value.
Information on version number, tted
hardware, 10-fold resolution
Softkeys 1…5
Select appropriate menu function, see also
Chapter 3.4.4.3.
No function
Alphanumeric keypad
Toggle key
Toggle by pressing:
- between alpha and numerical mode
- during conguration between weight units
Pressing once displays the corresponding rst character, e.g.,"A",
at the cursor position. After pressing twice, "B" is displayed at the
cursor position and after pressing three times, "C" is displayed.
Press the cursor key to nish entering a character or wait
approx. 2 seconds.
If only numeric values are required for input, letters are not enab-
led.
Press the cursor key within an entry to return to the previous
character.
Press the cursor key within an entry to select the next charac-
ter.
Within an input, pressing the delete key deletes the character
to the left of the cursor.
Transmitter in eld housing PR 5230 3 Device description
Minebea Intec EN-24
To Next Page
Loading...
