Chapter 1 Introduction
4 Lynx II DSA User's Manual - 7096089
Abbreviations and Acronyms
The following abbreviations and acronyms used throughout the manual are listed below:
CAM:
Configuration Access Method (used to store spectroscopy
data)
CNF: Spectral data file
CSV: Comma Separated Values file
Datasource or
data source
When used within a Genie 2000 context implies a Genie input
definition, whether be hardware or data file
DHCP: Dynamic Host Configuration Protocols
DSO: Digital Storage Oscilloscope
DSP: Digital Signal Processor
FPGA: Field Programmable Gate Array
GPIO: General Purpose Input/Output Connectors
ICR: Incoming Count Rate
MCA: Multichannel Analyzer
MCS: Multichannel Scaling
MSS: Multispectral Scaling
PHA: Pulse Height Analysis
SCA: Single Channel Analyzer
SNTP: Simple Network Time Protocol
SSDP Simple Service Discovery Protocol
RNDIS: Remote Network Driver Interface Specification
UPnP: Universal Plug and Play
URL: Uniform Resource Locator, also referred to as a Web Address
UTP: Unshielded Twisted Pair in reference to Ethernet cables
To Next Page
Loading...
