Mirion Technologies Lynx II DSA User Manual

Communicating with Lynx II
Lynx II DSA User's Manual – 7096089 65
GPIO Connectors
Your application determines the number of GPIO connections that may be required. The
figure below shows a GPIO MCX to BNC cable.
Figure 36: Sample GPIO MCX Cable
Communicating with Lynx II
Although Lynx II can be operated via Genie 2000, Apex, or ProSpect, or custom
applications installed on the host computer, the Lynx II also includes a very powerful user
interface that can be accessed from practically any web browser already on your PC,
tablet, or other devices.
The Lynx II supports Ethernet (TCP/IP) network connections over Ethernet and USB
interfaces. Refer to Communications Setup on page 153 for details.
The Lynx II DSA is shipped with factory 'default' settings including a special
administrator ID as indicated below. If your settings have been misplaced or forgotten, the
Lynx II system may be restored to factory settings, using procedures found in Factory
Reset Control on page 24.
Lynx Access – Default Settings
The default settings for each connection method are:
• Ethernet (default, preferred):…………………………10.0.0.3
• DHCP (dynamic address assignment):………………disabled
• USB:…………………………………………………10.0.1.4

Mirion Technologies Lynx II DSA Specifications

General

Brand	Mirion Technologies
Model	Lynx II DSA
Category	Measuring Instruments
Language	English