Maintenance
Lynx II DSA User's Manual – 7096089 133
Export Settings
The Export settings are used to save all current Lynx II settings into a CSV formatted file.
The contents include the parameter name, description, code, and value. Click on the
Select button and then enter a file name. Click on OK to save the settings as a CSV file.
Note: This is a Web browser-specific setting that will download the file where the
download’s settings location folder is configured to.
Export Spectral Data
The Export Spectral Data can be used to save the current spectral data into a CSV
formatted file. The contents include energy calibration, live and real times, and the
channel/energy per count. Click on the Select button and then enter a file name. Click on
OK to Click on OK to save the settings as a CSV file.
Note: This is a Web browser-specific setting that will download the file where the
download’s settings location folder is configured to.
Lynx II Reset to Factory Defaults
Select the Reset button to reset the Lynx II unit to its factory default values. A dialog will
be displayed to confirm resetting parameters to default values.
Performing a Factory Reset operation will reset all device parameters to
factory-default state, including all network parameters. This means that any
pre-established configurations that relied on non-factory default network
settings such as browser access and Genie MID Configurations will not
operate until the network parameters are restored to their original settings.
To Next Page
Loading...
Need help?
General
