11 - 10
11.3 Operation Settings
11.3.1 Operation setting functions
11.3 Operation Settings
11.3.1 Operation setting functions
Setting regarding GOT operation can be set.
The items which can be set are described below.
*1 Relationship between the "key sensitivity" setting and the "key reaction speed"
The relationship between "key sensitivity" and "key reaction speed" is shown in the table below.
•Decreasing the "key sensitivity" value will speed up the key reaction speed.
•Increasing the "key sensitivity" value will slow down the key reaction speed.
When the GOT screen recognizes a single touch as two touches, decrease the "key sensitivity" (to slow
down the key reaction speed).
Operation settings by GT Designer2
Set buzzer volume and window move buzzer volume by [GOT setup] in [System
Environment] of GT Designer2.
When change a part of the setting, change the setting by the GOT display setting
after downloading the project data.
GT Designer2 Version Screen Design Manual
(Section 3.8 Setting of the GOT display and operation (GOT setup))
Function Contents Setting range
Buzzer volume setting Buzzer volume setting can be changed.
OFF/SHORT/LONG
<At factory shipment:
SHORT>
Window move buzzer volume setting
Whether turn ON/OFF buzzer when move window
can be selected.
ON/OFF
<At factory shipment:
ON>
Security setting screen change
Security level change screen can be displayed.
Section 11.4 Security Level Change
Utility call key screen change
Utility call key setting screen can be displayed.
Section 11.5 Utility Call Key Setting
Key sensitivity setting
The sensitivity of touch panel when GOT screen is
touched can be set.
1 to 8
*1
"Key sensitivity" setting value 8 7 6 5 4 3 2 1
"Key reaction speed" [ms] -20 -10 Standard(±0) +10 +20 +40 +80 +120
To Next Page
Loading...
