8 - 11
8.6 USB Environmental Protection Cover
8.6.1 Applicable USB environmental protection cover
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
PART NAME
5
EMC DIRECTIVE
6
INSTALLATION
7
WIRING
8
OPTION
8.6 USB Environmental Protection Cover
The USB environmental protection cover protects the USB connector on the front face of GOT from dust,
water, and oil.
The GOT is installed with the USB environmental protection cover at factory shipment.
Replace when damage and deterioration are caused.
8.6.1 Applicable USB environmental protection cover
The following USB environmental protection cover is applicable for GT11 .
8.6.2 Installing procedure
1 Turn the GOT power off.
2 Disconnect the USB cable from the GOT if one is connected.
3 Open the USB environmental protection cover equipped with the GOT
and remove the mounting screws.
4 Remove the old USB environmental protection cover from the GOT to
replace it with the new USB environmental protection cover.
5 Fix the new USB environmental protection cover while fitting its
projection to the hole in the GOT, and mount the cover to the GOT, using
the mounting screws.
Precautions when the USB environmental protection cover is opened
Environmental protective structure of USB interface is "IP2X" when the USB
environmental protection cover is opened.
Product name Model Contents
USB environmental
protection cover
GT11-50UCOV
Environmental protection cover for USB interface on the main unit front
panel (conforming to IP67)
Tightening torque 0.36 to 0.48N•m for both mounting screws A and B
Mounting screw
Open.
USB environmental
protection cover
Projection
Mounting screw A
M3 6 pan head screw
Mounting screw B
To Next Page
Loading...
Need help?
General
