16 - 3
16.2 Prior Preparations for Installing BootOS and Standard Monitor OS
9
UTILITY FUNCTION
10
COMMUNICATION
INTERFACE
SETTING
11
DISPLAY AND
OPERATION
SETTINGS
12
CLOCK SETTINGS
AND BATTERY
STATUS DISPLAY
13
FILE DISPLAY AND
COPY
14
GOT SELF CHECK
15
CLEANING OF
DISPLAY SECTION
16
INSTALLATION OF
BOOTOS AND
STANDARD MONITOR OS
16.2 Prior Preparations for Installing BootOS
and Standard Monitor OS
For the installation using GOT, the CF card storing BootOS or Standard monitor OS is required.
For the method of writing BootOS and Standard monitor OS in the CF card, the following two methods are
available.
(1) [To Memory Card] from GT Designer2
GT Designer2 Version
Basic Operation/Data Transfer Manual
(8.8 Transferring Data Using a Memory Card)
(2) Uploading from other GOT (BootOS or Standard monitor OS has been installed)
Chapter 13 FILE DISPLAY AND COPY (PROGRAM/DATA CONTROL)
Precautions on writing BootOS, Standard monitor OS in CF card
When writing BootOS, Standard monitor OS, etc. in the CF card, be sure to execute
by the utility of other GOT or GT Designer2.
The installation is not executed properly with the CF card to which uploaded from
the utility of GOT or copied by softwares other than GT Designer2.
Note the available capacity of the CF card.
The available capacity of BootOS and Standard monitor OS can be confirmed by [To
Memory Card] of GT Designer2.
Capacity of data of OS to be transferred
To Next Page
Loading...
Need help?
General
