Mitsubishi GOT1000 GT11 - Display Contents of Communication Detail Settings

10 - 10
10.2 Communication Detail Settings
10.2.3 Display contents of communication detail settings
Communication parameter setting using GT Designer2
(1) Select [System Environment] [Communication Settings] from GT Designer2 to
enter the communication parameters for each communication driver.
To change the communication parameter setting after downloading project data,
change the setting at [Communication Detail Setting] (described in this section).
For [Communication Settings] using GT Designer 2, refer to the following manual.
GT Designer 2 Version Screen Design Manual
Section 3.7 Communication Interface Setting (Communication Settings)
10.2.3 Display contents of communication detail settings
Display items or setting items of communication detail settings depend on the type of communication driver
installed in the GOT.
For the setting contents of each driver, refer to the following.
GT Designer2 Version Screen Design Manual (Section 3.7 Communication Interface
Setting (Communication Settings)
This section describes the items that can be set using only the utility screen.
Keyword settings of MELSEC-FX
On the communication detail setting screen of MELSEC-FX, registration, deletion, cancellation, or protection
of the keyword for FX series PLC can be executed.
MELSEC FX