16 - 1
9
UTILITY FUNCTION
10
COMMUNICATION
INTERFACE
SETTING
11
DISPLAY AND
OPERATION
SETTINGS
12
CLOCK SETTINGS
AND BATTERY
STATUS DISPLAY
13
FILE DISPLAY AND
COPY
14
GOT SELF CHECK
15
CLEANING OF
DISPLAY SECTION
16
INSTALLATION OF
BOOTOS AND
STANDARD MONITOR OS
16.
INSTALLATION OF CoreOS, BOOTOS
AND STANDARD MONITOR OS
To execute the GOT utility, BootOS or Standard monitor OS has to be installed in the C drive (Flash
memory).
This chapter explains the installation using GOT.
For details of the installation using GT Designer2, refer to the following.
GT Designer2 Version Basic Operation/Data Transmission Manual
(8. TRANSFERRING DATA)
CoreOS
Section 16.1 to 16.4 of this chapter describes BootOS and Standard monitor OS
only.
For CoreOS, refer to the following.
Section 16.5 CoreOS
GRAPHIC OPERATION TERMINAL
GOT
1000
MITSUBISHI
When GOT is remote, installed
easily using the CF card
Install OS from GOT to GOT using
the CF card
BootOS or
standard monitor OS
installation
BootOS or
standard monitor OS
installation
CF card
GT Designer2
CF card
GOT
Write OS
file
Upload OS
file
GT Designer2 CF card GOT
GOT CF card GOT
GOT
GRAPHIC OPERATION TERMINAL
GOT
1000
MITSUBISHI
GOT
GRAPHIC OPERATION TERMINAL
GOT
1000
MITSUBISHI
Install the
CF card in GOT
Install the
CF card in GOT
To Next Page
Loading...
