NEC SL 1000 - Page 28

Item No. Item Input Data Description Default
02 Logical Port Number [0 : No setting] = 0
[1 : T-Point] = 96
[2 : S-Point] = 120
[3 ~ 5 : NW Mode] = 0
[6 : S-Point (Leased Line)] = 1 ~ 120
The starting port
number of a BRI line
is displayed. Two
logic ports are auto-
matically assigned to
a BRI line.
0
03 Connection Type 0 = Point-to-Multipoint
1 = Point-to-Point
0
04 Layer 3 Timer Type 1 ~ 5
Each timer value of
Layer 3 is set up for
every type using Pro-
gram 81-06 (T-Bus).
1
05 CLIP Information An-
nouncement
0 = No
1 = Yes
Based on this setting, the
system includes a Pre-
sentation Allowed (1) or
Presentation Restricted
(0) in the Setup message
to allow or deny the Call-
ing Party Number. Pro-
gram 15-01-04 must also
be set to 1 if this option is
enabled.
1
06 Connection Bus Mode 0 = Extended passive bus
1 = Short passive bus
0
07 S-point DDI digits 0 ~ 4 0
08 Dial Sending Mode 0 = Enblock Sending
1 = Overlap Sending
ISDN Protocol definition 1
09 Dial Information Element 0 = Keypad Facility
1 = Called Party Number
ISDN Protocol definition
[Only when Dialing Send-
ing Mode (10-03-08) is
set for 1 (Overlap Send-
ing]
1
14 Service Protocol for S-point 0 = Keypad facility
1 = Specified Protocol for Aspire sys-
tem
0
15 Call Busy Mode for S-point 0 = Alerting
1 = Disconnect
0
17 ISDN Line Ringback Tone 0 = Disable
1 = Enable
System can provide ring-
back tone, if set to 1 : En-
able.
0
18 Type of Number 0 = Unknown
1 = International number
2 = National number
3 = Network specific number
4 = Subscriber number
5 = Abbreviated number
ISDN Protocol definition 0
19 Numbering Plan Identifica-
tion
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
ISDN Protocol definition 0
24 Power feeding for S-point 0 = Disable
1 = Enable
0
25 Layer 1 Supervision (V3.0
Added)
0 = Disable
1 = Enable
1
25 Layer 1 Supervision (V3.0
Added)
0 = Disable
1 = Enable
1
SL1000/SL1100 ISSUE 3.01
2-6 Program 10 : System Configuration Setup
Program
10