NEC Univerge SV9100 - Page 145

Issue 2.0
4-66 Features and Specifications
Restrictions:
 Program 20-02-15 (Caller ID Display Mode) must be set to 0 to display the DID
Name on incoming
DID calls.
Refer to the Key-Common Channel Interoffice Signaling (K-CCIS) feature for more
details related to Single Line Telephone and IP (K-CCIS) support.
RELATED FEATURE LIST
 Key-Common Channel Interoffice Signaling (K-CCIS)
 Flexible Numbering of Stations – K-CCIS
 Uniform Numbering Plan – K-CCIS
GUIDE TO FEATURE PROGRAMMING
This guide provides a list of associated Programs that support this feature.
Program/
Item No.
Description/Selection Assigned Data Comments
22-09-01 DID Basic data Setup –
Expected Number of Digits
1~8
Default is 4
Assign number of digits the Table expects to
receive from Telco. Use this program to make the
system compatible with three- and four- digit DID
service.
22-10-01 DID Translation Table Setup
– Conversion Table Area
Number
0 = No setting
1~2000
Default is 0
Program the Translation Table size.
22-11-01 DID Translation Number
Conversion – Received
Number
Maximum eight digits
Default is No Setting
Assign the received number to the Conversion
Table number.
22-11-02 DID Translation Number
Conversion – Target
Number
Maximum 24 digits
Default is No Setting.
Assign the destination extension based on the
digits received.
22-11-03 DID Translation Number
Conversion – DID Name
Maximum 12 digits
Default is No Setting
Assign the DID Name based on the digits received.