NEC Univerge SV9100

Issue 2.0
SV9100 Networking Manual 1-7
SECTION 3 NETWORK STRUCTURE CONSIDERATIONS
3.1 Determining System Configurations
The configuration of the network and the number of lines (channels) is determined
by the traffic between each office.
The topologies listed in this section are supported in the UNIVERGE SV9100
system KTS-to-KTS structure.
 Star Topology – Refer to Figure 1-6 Star Topology (KTS-to-KTS or
PBX-to-KTS).
 Tree Topology – Refer to Figure 1-7 Tree Topology (KTS-to-KTS or
PBX-to-KTS).
13 m
14 CB4
15 m
16 0
17 m
18 CB5
19 m
20 1
21 m
22 CB6
23 m
24 1
 The S-bit is the first bit in each frame.
Frames are repeated in the order shown in this table.
The letter m in the 4 kbps Data Link column indicates the frame is usually
assigned to 1.
Table 1-2 24-Multiframe Bit Assignment (Continued)
Frame
Number
S-Bit
Frame
Synchronization
4 kbps
Data Link
CRC