NEC Univerge SV9100

SV9100 Networking Manual xix
LIST OF FIGURES
Introduction
Book 1 – SV9100 K-CCIS
Chapter 1 General Information <US Only>
Figure 1-1 K-CCIS System Outline .................................................................................................1-1
Figure 1-2 Clock Supply Route .......................................................................................................1-2
Figure 1-3 K-CCIS System Configuration .......................................................................................1-3
Figure 1-4 Frame Configuration of 24-DTI (12 Multiframe) .............................................................1-4
Figure 1-5 Frame Configuration of 24-DTI (24 Multiframe) .............................................................1-6
Figure 1-6 Star Topology (KTS-to-KTS or PBX-to-KTS) .................................................................1-8
Figure 1-7 Tree Topology (KTS-to-KTS or PBX-to-KTS) ................................................................1-9
Figure 1-8 Mesh Topology (PBX-to-KTS) .....................................................................................1-10
Figure 1-9 K-CCIS Routes ............................................................................................................1-11
Figure 1-10 Assigning One Common Signaling Channel Between Two Systems ..........................1-11
Figure 1-11 One GCD-CCTA Assigned per Common Signaling Channel ......................................1-12
Figure 1-12 Common Signaling Channel - Example of Incorrect Connection .................................1-12
Figure 1-13 Point Code Determinations ..........................................................................................1-13
Figure 1-14 CCH Linking .................................................................................................................1-14
Figure 1-15 Circuit Identification Codes (CIC) .................................................................................1-16
Figure 1-16 Closed Numbering Plan Example ................................................................................1-18
Figure 1-17 Open Numbering Plan Example ..................................................................................1-19
Chapter 2 Hardware Installation <US Only>
Figure 2-1 Inserting Blades in the 19” Chassis ...............................................................................2-2
Figure 2-2 GCD-CCTA Blade ..........................................................................................................2-5
Figure 2-3 GCD-CCTA LED Indication Pattern of Layer 1 on T1 Unit ............................................2-7
Chapter 3 System Data Programming <US Only>