NEC Univerge SV9100

Issue 2.0
SV9100 Networking Manual 9-15
5.1.4 IP Extension Numbering
Use these programs to assign IP extension numbering.
5.1.5 SIP Extension CODEC Information
Use these programs assign SIP extension CODEC information.
Program
Number
Program Name
Description/
Comments
Assigned Data 1 2 3
11-01-01
System Numbering Refer to the SV9100
Programming Manual
for all options and
default settings.
1 = 3 Digit; Intercom
Default is 3 Digit; Intercom
X
11-02-01
Extension Numbering Assign up to eight digits
for extension numbering
Dial (Up to eight digits)
Default
Ports 1~300 = 200~499
Ports 301~960 =
5000~5659
X
Program
Number
Program Name
Description/
Comments
Assigned Data 1 2 3
84-19-01
SIP Extension CODEC
Information Basic Setup –
Number of G.711 Audio
Frames
Define the G.711 audio
Frame Size
1~4
1 = 10ms
2 = 20ms
3 = 30ms
4 = 40ms
Default is 2
84-19-02
SIP Extension CODEC
Information Basic Setup –
G.711 Voice Activity
Detection Mode
Enable/Disable Voice
Activity Detection for
G.711.
0 = Disable
1 = Enable
Default is 0
84-19-03
SIP Extension CODEC
Information Basic Setup –
G.711 Type
Define the G.711 Type –
-law is recommended
in USA.
0 = A-law
1 = -law
Default is 0
84-19-04
SIP Extension CODEC
Information Basic Setup –
G.711 Jitter Buffer (min)
Define G.711 Jitter
Buffer minimum
accepted value.
0~300ms
Default is 20
84-19-05
SIP Extension CODEC
Information Basic Setup –
G.711 Jitter Buffer
(Average)
Define G.711 Jitter
Buffer setting.
0~300ms
Default is 40