NEC Univerge SV9100

Issue 2.0
SV9100 Networking Manual 3-11
1.7 Open Number Programming Example
This sections provides the steps needed to program an open numbering plan.
Step 1: T1 Tie Lines
The following diagram provides an example of Program and item numbers that
should be assigned for T1 Tie lines. The example assumes that each UNIVERGE
SV9100 and Electra Elite IPK II system is defaulted with the GCD-CCTA blades
installed.
Abbreviations used in the diagram:
MB = Memory Block TRK = Trunk TG = Trunk Group
CC = Clear Channel TT = Trunk Type
PRG 10-03-05 PRG 10-03-05 PRG 10-03-05
Internal
External
Internal
External
PRG 10-03-03 PRG 10-03-03 PRG 10-03-03
CC = B8ZS CC = B8ZS CC = B8ZS
PRG 22-02-01 PRG 22-02-01 PRG 22-02-01
TRK 001~024 = Tie TRK 001~024 = Tie TRK 001~024 = Tie
TRK 025~048 = Tie
PRG 14-05-01 PRG 14-05-01 PRG 14-05-01
TRK 001~024 = TG 10 TRK 001~024 = TG 10 TRK 001~024 = TG 10
TRK 025~048 = TG 11
PRG 14-02-13 PRG 14-02-13 PRG 14-02-13
TRK 001~024 = Yes TRK 001~024 = Yes TRK 001~024 = Yes
TRK 025~048 = Yes
PRG 22-02-01 PRG 22-02-01 PRG 22-02-01
TRK 001~024 = Tie TRK 001~024 = Tie TRK 001~024 = Tie
TRK 024~048 = Tie
PRG 34-01-01 PRG 34-01-01 PRG 34-01-01
TRK 001~024 = Wink TRK 001~024 = Wink TRK 001~024 = Wink
TRK 025~048 = Wink
TG 10 TG 10
UNIVERGE
SV9100
UNIVERGE
SV9100
Electra Elite
IPK II
(101s)
(201s)
(301s)
TG 11
TG 10
Tie Lines
101~130
101~130
101~130
Tie Lines
25
27
26