NEC Univerge SV9100

Issue 2.0
SV9100 Networking Manual 11-3
1.2.4 License
 The system must be licensed for this feature (License 0031).
 The system must be licensed for DT800/DT700 ITL Terminals.
 IP Terminal License (5111)
 System Port License (0300)
 Version 1 License (0411)
1.3 Installation
The following settings have been added for NAT traversal in the DT800/DT700
ITL Terminal.
 Terminals must be V3.0.0.0 or higher to support the NAPT feature.
1.3.1 Settings for Terminals
NAT Traversal 2. SIP Settings/ 8. NAT Traversal [Eco, Value, Sophisticated]
Number
and Name
of Setting
Setting
Value
Default
Value
Factory
Value
Auto
Config
Description
1. NAT
Traversal
Mode
1. Disable
2. Dynamic
3. Static
1.
Disable
Available Available Settings for NAT Traversal:
Disable: Disables NAT Traversal
Dynamic: Performs NAT
Traversal using a dynamic
conversion table.
Static: Performs NAT Traversal
using a static conversion table and
requires the WAN IP Address to
be entered into the IP Terminal.
2. Network
Area Name
A character
string
No value Available Available The name of the network area to
which terminals belong. Specify
up to 32 alphanumeric characters.
(Optional step)
3. WAN
Settings
See table below.