NEC Univerge SV9100

Issue 2.0
3-4 General IP Configuration
Assume that a UNIVERGE SV9100 is added to the existing data network. The
Network Administrator (or IT Manager) should provide the following:
 IP Address (for the GCD-CP10 blade)
 IP Addresses (for the GPZ-IPLE daughter board)
 Subnet Mask
 Default Gateway
 A spare switch/hub port
First, program the UNIVERGE SV9100:
 192.168.1.200
 255.255.255.0
 PRG10-12-03: 192.168.1.254
 A system reset is required for the IP Address changes to take effect.
Now connect the GCD-CP10 blade Ethernet Port to the switch/hub port, using a
standard Cat-5 patch cable. The UNIVERGE SV9100 is now configured on the
network and should be accessible by other devices on the network. Refer to
Figure 3-2 Example Configuration 1 - Adding the UNIVERGE SV9100 Chassis to
the Network.