NEC Univerge SV9100

Issue 2.0
SV9100 Networking Manual 4-3
SECTION 3 HOW TO EXIT PROGRAMMING MODE
To exit the programming mode:
To exit programming mode, first exit the programming options mode.
1. Press Answer to exit program options, if needed.
2. Press Speaker. If changes were made to the system programming, Saving System
Data is displayed.
3. When completed, the display shows Complete Data Save and exits the telephone to
idle.
 To save a customer database, a blank USB Drive is required. Insert the USB Drive
into the GCD-CP10 and, use Program 90-03, to save the software to the USB Drive.
(Use Program 90-04 to reload the customer data if necessary). A USB Drive can
hold only one customer database. Each database to be saved requires a separate
drive.
SECTION 4 USING KEYS TO MOVE AROUND IN THE PROGRAMS
Once you enter the programming mode, use the keys in the following chart to enter
data, edit data and move around in the menus.
Program Mode
Base Service OP1 OP2
Table 4-1 Keys for Entering Data
Keys for Entering Data
Use this key... When you want to...
0~9 and 
Enter data into a program.
Transfer
Complete the programming step you just made (e.g., pressing Enter on a
PC keyboard). When a program entry displays, press Transfer to bypass
the entry without changing it.
Conf
Delete the entry to the left (e.g., pressing Backspace on a PC keyboard).
Hold
Delete or clear all characters to the right of the cursor.
Answer
Exit one step at a time from the program window currently being viewed.
For example, if programming item 5 in 15-03, pressing Answer allows you
to enter a new option in program 15-03. Pressing Answer again allows
you to select a new program in the 15-XX series. Pressing Answer a third
time allows you to enter a new program beginning with 1. Pressing
Answer one last time brings you to the beginning program display,
allowing you to enter any program number.