NEC Univerge SV9100 - Page 266

Issue 2.0
4-2 Programming
The second row of the display KY01 = *01 indicates that Key 01 is being
programmed with the entry of *01. The third row allows you to move the cursor to
the left or right, depending on which arrow is pressed.
To learn how to enter the programming mode, refer to Section 2 How to Enter
Programming Mode below.
SECTION 2 HOW TO ENTER PROGRAMMING MODE
To enter programming mode:
1. Go to any working display telephone.
 In a newly installed system, use extension (port 1).
2. Do not lift the handset.
3. Press Speaker.
4.
#  # 
5. Dial the system password + Transfer.
Refer to the following table for the default system passwords. To change the
passwords, use 90-02 : Programming Password Setup.
Password
Password
User
Name
Level Programs at this Level
---- ---- 1 (MF)
Manufacturer (MF):
All programs
12345678 tech 2 (IN) Installation (IN):
All programs in this section not listed below for SA
and SB
0000 ADMIN1 3 (SA) System Administrator - Level 1 (SA):
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16,
10-17, 10-18, 10-22, 12-02, 12-03, 12-04, 15-01,
15-07, 15-09, 15-10, 15-11, 20-16, 21-07, 21-14,
22-04, 22-11, 25-08, 30-03, 32-02, 40-02, 41-02,
41-03, 41-04, 41-05, 41-06, 41-07, 41-08, 41-09,
41-10, 41-11, 41-12, 41-13, 41-14, 41-15, 41-16,
41-17, 41-18, 90-03, 90-04, 90-06, 90-07, 90-18,
90-19
9999 ADMIN2 4 (SB) System Administrator - Level 2 (SB):
13-04, 13-05, 13-06