NEC Univerge SV9100

Issue 2.0
3-2 System Data Programming <US Only>
10-03-06
Blade Setup – Number
of Ports
Auto
4 Ports
8 Ports
12 Ports
16 Ports
20 Ports
10-03-07
Blade Setup – Wiring
Type
Auto
Cross
Straight
14-05-01
Trunk Group
Assign Trunk to Trunk
Groups/Outbound Priority
Trunk Group = 1~100
Default is 1
Priority = 1 ~ 400
Default priorities for trunks
1 ~ 400 is 1 ~ 400.
22-02-01
Incoming Call Trunk Setup
0 = Normal (default)
1 = VRS (second dial
tone if no VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie Line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
Set the feature type for the trunk
you are programming.
34-01-01
E&M Tie Line Basic Setup
– DID/E&M Start Signaling
0 = 2nd Dial Tone
1 = Wink
2 = Immediate
3 = Delay
Default is 1
Set the signaling mode for DID
and Tie trunks. DID and Tie
trunks can use either Immediate
start or Wink start signaling.
Table 3-1 Digital Trunk Data Programming Assignments (Continued)
Program/
Item No.
Description/Selection Assigned Data Comments