NEC Univerge SV9100

SV9100 Networking Manual 5-1
Chapter 5
UNIVERGE
®
SV9100
SV9100 IP K-CCIS
This chapter describes the system outline, Hardware installation, and programming
procedures for providing
IP K-CCIS using the GPZ-IPLE on the UNIVERGE SV9100
system.
SECTION 1 SYSTEM OUTLINE
1.1 IP K-CCIS Application using the GPZ-IPLE
The system uses the GPZ-IPLE to connect multiple systems together over a Data
Communication IP Network (Intranet). Key-Common Channel Interoffice Signaling
(K-CCIS) is used to provide telephony services between the UNIVERGE SV9100
and another UNIVERGE SV9100 or a NEAX PBX system.
1.1.1 CCIS Networking via IP (Non Peer-to-Peer Connections Basis)
 IP trunk connections over CCIS Networking via IP is used to provide
telephony services between the UNIVERGE SV9100 and UNIVERGE
SV9100 and a NEAX IPS, IPX, SV7000, UNIVERGE SV8100 and
UNIVERGE SV9300.
 The SV9100 uses the NEC proprietary CCIS Peer-to-Peer protocol
over IP to communicate between system to system.