Issue 2.0
13-58 AspireNet
4.7 Using Softkeys For Programming
Each UNIVERGE SV9100 display telephone provides interactive Softkeys for intuitive feature
access. The options for these keys will automatically change depending on where you are in the
system programming. Simply press the Softkey located below the option you wish and the
display will change accordingly.
Pressing the VOLUME or VOLUME will scroll between the menus.
3
Enter characters: D-F, d-f, 3.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “
# $ % & ’ ( ) ô Õ ú ä ö ü
*
Enter characters:
* + , - . / : ; < = > ?
π Σ Ω ¢ £
#
#
= Accepts an entry (only required if two letters on the same
key are needed – ex: TOM). Pressing
# again = Space. (In
system programming mode, use the right arrow Softkey
instead to accept and/or add a space.)
Recall
Delete the entry to the left.
Hold
Clear all the entries from the point of the flashing cursor and to
the right.
_
Program Mode
Base Service OP1 OP2
_
Program Mode
CCIS Hard Mtnance
Table 13-3 Keys for Entering Names
Use this keypad digit . .
.
When you want to. . .
To Next Page
Loading...
