NEC Univerge SV9100

Issue 2.0
11-2 NAPT
The example below is with 256 DSP Resources licensed to the GCD-CP10. Your
Port forwarding range could change depending on number of DSP Resource
Licenses.
1.2 Requirements
The following information provides requirements for NAPT.
1.2.1 Main Software
NAPT is supported with the V1000/V1.00 or higher release of the SV9100.
1.2.2 Hardware
The SV9100 requires the following hardware:
 GCD-CP10
 GPZ-IPLE
1.2.3 Capacity
896 Extensions (as allowed by hardware and licensing).
Figure 11-1 NAPT Configuration Example