NEC Univerge SV9100

Issue 2.0
SV9100 Networking Manual 13-25
3.8 Caller ID Display
Caller ID information can be sent to the target extension in a networked system and show the Caller ID on
the phone’s display. The ABB Name is also shown on LCD by searching ABB table at the target system.
Operation
A DDI call routed directly to a remote extension will send the Caller ID information to the remote system.
The DDI name set in Program 22-11-03 is also sent to the remote system.
At the remote system the Caller ID information will be displayed or, if the Caller ID number matches an
Abbreviated Dial entry the Abbreviated Dial name will be displayed.
A trunk call that is first answered and then transferred to a remote extension will display the Caller ID num-
ber and the DDI name. The Abbreviated Dial name will NOT be displayed.
Related Programs
° 20-09-02 : Class of Service Options (Incoming Call Service) - Caller ID Display
Define the option whether display Caller ID or not in each station port.
° 20-09-03 : Class of Service Options (Incoming Call Service) - Sub-Address Identification
Define whether an extension displays the Caller Sub-Address.
° 13-04 : Abbreviated Dialing Number and Name
Define the abbreviated dialing number and name. The ABB name will be shown on a phone’s LCD when
the ABB table has a matching number with the incoming Caller ID. The common abbreviated number table
is used to search for a match.
Item
No.
Item
Input
data
Default
COS
01-14
COS 15
02
Caller ID Display
Enables/disables the Caller ID display at an
extension.
0-Off
1-On
11
Item
No.
Item
Input
data
Default
COS
01-14
COS 15
03
Sub Address Identification
Define whether an extension displays the Caller
Sub-Address.
0-Off
1-On
00
Item
No.
Item Input Data Default
01 Abbreviated Dialing Data 1-9, 0, *, #,
Pause (Press line key 1),
Recall/Flash (Press line key 2),
@ for Additional Digit for ISDN
Functionality (Press line key 3)
(max. 24 digits)
No Setting
02 Name Max. 12 Characters No Setting