Issue 2.0
SV9100 Networking Manual 4-107
Voice Call – K -CCIS
FEATURE DESCRIPTION
This feature provides a voice path, through the K-CCIS network, between a MLT in
one office and a MLT
in another office. This path is established from the calling party
to the called party built-in speaker. If the called party MIC is on, the called party can
converse hands-free.
SYSTEM AVAILABILITY
Terminal Type:
All multiline terminals
Required Components:
GCD-CCTA
- OR -
GPZ-IPLE
OPERATING PROCEDURES
From one MLT to another MLT:
1. The originating MLT user dials the desired station number in a different office
and receives ring back tone.
2. Calling party dials 1. A signal tone is transmitted over the K-CCIS network to
the called party speaker.
3. The called party can press MIC, or press FEATURE and dial 1 (if the MIC
LED is not on) to allow two-way conversation with the calling party.
SERVICE CONDITIONS
General:
The UNIVERGE SV9100 can assign a Feature Access/One Touch Button as a
Voice Call key. This performs the same operation as pressing 1.
Any station in the same system can use Directed Call Pick Up to retrieve the
Voice Call over K-CCIS.
When a Voice Call is sent to a station that is unable to receive voice
announcement, RST is displayed on the originator display.
To Next Page
Loading...
