NEC Univerge SV9100 - Page 73

Issue 2.0
3-12 System Data Programming <US Only>
Step 2: Open Numbering Plan
The following diagram provides an example of Programs and item numbers that
should be assigned for Open Numbering. The example assumes that Step 1: T1
Tie Lines was completed.
Abbreviations used in the diagram:
AC = Access Code ACG = Access Item Code MB = Memory Block
RT = Route TB = ARS Table PRG =Program
TG 10 TG 10
UNIVERGE
SV9100
UNIVERGE
SV9100
Electra Elite
IPK II
(101s)
(101s)
(101s)
TG 11
TG 10
Tie Lines
101~130
101~130
101~130
Tie Lines
25
25
27
26
Calling Calling Calling
101 ~ 130 101 ~ 130 101 ~ 130
PRG 11-01-01 PRG 11-01-01 PRG 11-01-01
Dial 1X = 3 Digits; Intercom Dial 1X = 3 Digits; Intercom Dial 1X = 3 Digits; Intercom
Dial 8X = 1 Digit, F-Route Access Dial 8X = 1 Digit, F-Route Access Dial 8X = 1 Digit, F-Route
PRG 11-02-01 PRG 11-02-01 PRG 11-02-01
Port 1 = 101 Port 1 = 101 Port 1 = 101
PRG 44-02-01 PRG 44-02-01 PRG 44-02-01
F-Route TBL1 = 825 TBL1 = 825 F-Route TBL1 = 825
F-Route TBL2 = 826 TBL2 = 826 F-Route TBL2 = 826
F-Route TBL3 = 827 TBL3 = 827 F-Route TBL3 = 827
PRG 44-02-02 PRG 44-02-02 PRG 44-02-02
TBL1 = F-Route TBL1 = F-Route TBL1 = F-Route
TBL2 = F-Route TBL2 = F-Route TBL2 = F-Route
TBL3 = F-Route TBL3 = F-Route TBL3 = F-Route
PRG 44-02-03 PRG 44-02-03 PRG 44-02-03
TBL1 = F-Route TBL1 TBL1 = F-Route 1 TBL1 = F-Route 1
TBL2 = F-Route TBL2 TBL2 = F-Route 2 TBL2 = F-Route 2
TBL3 = F-Route TBL2 TBL3 = F-Route 3 TBL3 = F-Route 2
PRG 44-05-01 PRG 44-05-01 PRG 44-05-01
TBL1 = TG 255 TBL1 = TG 10 TBL1 = TG 10
TBL2 = TG 10 TBL2 = TG 255 TBL2 = TG 10
TBL3 = TG 11 TBL3 = TG 255