Issue 2.0
SV9100 Networking Manual 4-83
To set Call Forward – All Calls – K-CCIS from a Multiline Telephone (Open
Numbering Plan):
1. Press the Call Forward – All Call ON/OFF key, and Dial 1 to set.
2. Dial the trunk Access Code (normally 8).
3. Dial the Office Code number.
4. Dial the distant K-CCIS station number.
5. Press Speaker.
- OR -
1. Lift the handset or press Speaker.
2. Dial Access Code
741 (set as default), and Dial 1 to set.
3. Dial the trunk Access Code (normally 8).
4. Dial the Office Code number.
5. Dial the distant K-CCIS station number.
6. Restore handset or press Speaker.
To cancel Call Forward – All Calls – K-CCIS from a Multiline Telephone:
1. Press Call Forward – All Call On/Off key.
2. Dial 0 to cancel.
3. Press Speaker.
- OR -
1. Lift the handset or press Speaker.
2. Dial Access Code
741 (set as default), and Dial 0 to cancel.
3. Restore handset or press Speaker.
SERVICE CONDITIONS
General:
Multiple Call Forwarding – All Calls – K-CCIS can forward a call up to seven
times across K-CCIS links (up to seven hops) depending on system data.
Multiple Call Forwarding over a K-CCIS link is combined with Multiple Call
Forwarding – All Calls/Busy/No Answer.
If the calling station is set as the destination in a multiple hop scenario, Multiple
Call Forwarding – All Calls – K-CCIS is not performed (i.e., an infinite loop does
not occur).
To Next Page
Loading...
