Issue 2.0
SV9100 Networking Manual 4-5
SECTION 6 USING SOFTKEYS FOR PROGRAMMING
Each UNIVERGE SV9100 display telephone provides interactive Softkeys for
intuitive feature access. The options for these keys will automatically change
depending on where you are in the system programming. Simply press the Softkey
located below the option you wish and the display will change accordingly.
Pressing the VOLUME or VOLUME will scroll between the menus.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü
Enter characters:
+ , - . / : ; < = > ? B E S ¢ £
#
#
= Accepts an entry (only required if two letters on the same key
are needed – ex: TOM). Pressing
# again = Space. (In system
programming mode, use the right arrow Softkey instead to accept
and/or add a space.)
Conf
Clear the character entry one character at a time.
Hold
Clear all the entries from the point of the flashing cursor and to the
right.
Table 4-2 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
_
Program Mode
Base Service OP1 OP2
To Next Page
Loading...
