NEC Univerge SV9100 - Page 390

Issue 2.0
SV9100 Networking Manual 7-13
PRG 22-02-01 Set all IP Trunks to TIE
PRG 44-02-01 (Table 1) 4 1
PRG 44-02-02 (Table 1) F-Route F-Route
PRG 44-02-03 (Table 1) 1 1
PRG 44-05-01 (F-Route
1)
Trunk Group 10 Trunk Group 10
PRG 44-05-09 (Max
Digits)
33
PRG 84-26-01 (DSP) 192.168.1.11 192.168.2.11
H.323 Settings
PRG 10-68-01 Enable H.323 Trunk
Availability
Enable H.323 Trunk Availability
PRG 10-68-02 Define the Start Port
Number
Define the Start Port Number
PRG 10-68-03 Assign the number of
Ports (4 Ports)
Assign the number of Ports (4
Ports)
PRG 10-17-01 Manual Manual
PRG 10-17-02 192.168.1.10 192.168.2.10
PRG 10-18-01 50 51
PRG 10-23-01 Enable System Interconnection (Yes)
PRG 10-23-02 Assign the IP Address of
the Distant System
(192.168.2.10)
Assign the IP Address of the
Distant System (192.168.1.10)
PRG 10-23-04 Starting digit of the Distant
System Extension Number
Starting digit of the Distant
System Extension Number
* GCD-CP10 reset is required after making changes to this Programs.
Program Main Site (Office A) Remote Site (Office B)