NEC Univerge SV9100 - Page 497

Issue 2.0
10-10 SV9100 NetLink
 After seven days or 28 days the license expires. To renew the license,
a connection to the original Primary site must be re-established.
(Once the connection to the Primary is recovered, if fail-over occurs
again, the license is once again enabled for the specified duration
based on software version above.)
 If the original Primary site is in the NetLink network as a temporary
secondary, the license information is available.
 If a user wants to enter another additional feature license, it needs to
be entered on the original Primary System.
 When fail-over occurs, the Primary System is changed to another
communication server. The IP applications do not know the new
primary IP Address, so the following features are disabled after fail-
over:
 SMDR
 ACD-MIS
 SIP Terminal
 Soft Phone
 IP K-CCIS
 The following Programs are not updated by the Primary System
during fail-over:
 Program 10-01, Program 10-02, Program 10-12, Program 10-13,
Program 10-14, Program 10-15, Program 10-16, Program 10-45,
Program 51-01, Program 90-01 or Program 90-09.
 Data in SRAM area is not transferred to the Secondary Systems
during fail-over, therefore when fail-over occurs DND and Caller ID
History may be lost.
 Mobile Extension is supported only when using the PRI installed in
the Primary System.
 When a Secondary System with an ETIA or RTB assigned is added to
a NetLink network, the Primary Systems database does not replicate
the data in Programs 10-55 or 90-61.
 When External MOH is assigned, the AUX1 or AUX2 on the front of
the GCD-CP10 can only be utilized at the Primary Site. All Secondary
sites must provide the External MOH input via an ACI Input [PGD(2)-
U10 ADP].
 A DT800/DT700 may be registered to either the primary or a
secondary NetLink system. When NetLink is turned on, the system
refers to programs 51-17-01 and 51-17-02 for DT800/DT700 registrar
information.
 With both the Primary Site and Secondary Sites can have their own
local MOH source connected to the AUX1 or AUX2 on the front of the
GCD-CP10.