Issue 2.0
SV9100 Networking Manual 13-13
Step 3: Assign a function to the code selected
After entering a code and specifying its length, you must assign its function. This is the Dial Type column in the
table. The choices are:
--Changing the Dial Type for a range of codes can have a dramatic affect on how your system operates.
Assume, for example, the site is a hotel that has room numbers from 100-399. In order to make extension
numbers correspond to room numbers, you should:
- In Program 11-02, reassign extension numbers on each floor from 100 to 399.
(Other applications might also require you to change entries in Program 11-10 through 11-16.)
Dial
Types
Dial Type Description Related Program
0 - Not Used -
1 Service Code 11-10: Service Code Setup (for System Administrator)
11-11: Service Code Setup (for Registration)
11-12: Service Code Setup (for Service Access)
11-13: Service Code Setup (for ACD)
11-14: Service Code Setup (for HOTEL)
11-15: Service Code Setup (Special access)
2 Extension Number 11-02: Extension Numbers
11-04: Virtual Extension Numbers
11-06: 2PGDAD (ACI) Extension Numbers
11-07: Department Calling Group Numbers
11-08: 2PGDAD (ACI) Group Pilot Numbers
3 Trunk Access Code 11-09: Trunk Access Code.
4 Special Trunk Access 11-09: Trunk Access Code.
5 Operator Access 20-17: Operator’s Extension
6 ARS/F-Route Access 44-xx
8 Networking 10-03: PCB Setup
10-12: GCD-CP10 Network Setup
10-20: LAN Setup for External Equipment
10-27: IP System ID
To Next Page
Loading...
