Issue 2.0
3-6 System Data Programming <US Only>
44-05-02
ARS/F-Route Table –
Delete Digits
0 = No Setting
1 ~ 255 = Number of digits
to delete
(255 = Delete All)
Default is 0
Enter the number of digits to be
deleted from the dialed number.
44-05-03
ARS/F-Route Table –
Additional Dial Number
Tabl e
0 = No Setting
1 ~ 1000 = Add Table in
Program 44-06-01
Default is 0
Enter the table number defined in
Program 44-06 for additional
digits to be dialed.
44-05-04
ARS/F-Route Table –
Beep tone
0 = Off
1 = On
Default is 0
Select whether or not a beep is
heard if a lower priority trunk
group is used to dial out.
44--05-05
ARS/F-Route Table –
Gain Table Number for
Internal Calls
0 = No Setting
1 ~ 500
Default is 0
Select the gain table number to
be used for the internal call
defined in Program 44-07.
44-05-06
ARS/F-Route Table –
Gain Table Number for
Tandem Connections
0 = No Setting
1 ~ 500
Default is 0
Select the gain table number to
be used for the internal call
defined in Program 44-07.
44-05-07
ARS/F-Route Table –
ARS Class of Service
0 = No Setting
1 ~ 16
Default is 0
Select the ARS Class of Service
to be used for the table. An
extension ARS COS is
determined in Program 26-04-01.
44-05-08
ARS/F-Route Table –
Dial Treatment
0 = No Setting
1 ~ 15
Default is 0
If a Dial Treatment is selected,
Programs 44-05-02 and
44-05-03 are ignored and the
Dial Treatment defined in
Program 26-03-01 is used
instead.
44-05-09
ARS/F-Route Table –
Maximum Digit
Assignment
0 = No Maximum
1 ~ 24
Default is 0
Assign the Maximum Digits for K-
CCIS or ISDN Calls.
Table 3-5 Open Numbering Plan Assignments (Continued)
Program/
Item No.
Description/
Selection
Assigned Data Comments
To Next Page
Loading...
